3/19/2024 0 Comments Pingplotter udp testService timestamps log datetime msec localtime show-timezoneĮnable secret 5 $1$d2Pf$9XcHPYKJ5Ctt9PGT47EEV. Service timestamps debug datetime msec localtime show-timezone !This is the running config of the router: 10.10.11.1 Before I did that, the VPN would not come up.īelow is the current config: ( I made comments along the way ) It accepted it and therefore I now have access to the outside world. I made the change by using the IP Gateway comand line. Prior to changing the Modem out, and having a gateway of 0.0.0.0 I was able to access the internet. Before I did that, I was not able to access the internet from the cisco. The configuration hasnt changed from when it was working.įrontier (ISP) changed from a standard Modem to a Modem/Router with PPPOE.Īll I did was change the Gateway from 0.0.0.0 to the given gateway from the ISP. How can I tell if its the router causing the problem or the Modem? I pingplott INTO the router from another network and it goes allt he way through till it hits the modem. I do a pingplotter test out of that router to another Static ip (our own internet connection through Charter Communications) and I get 100% packetloss across all the HOPS. The modem is setup as PPPOE instead of bridge with a single static IP. The only change I made to the router here is entered a gateway (before it was 0.0.0.0 and it worked fine) and changed teh DNS numbers (which really dont matter too much as there is no internet data). I got the VPN back up but it drops packets left and right.Neither router has computer data going across it, it is all radio traffic for a taxi company. We had teh ISP come in and check everything outa nd he swapped modems. Last sunday the VPN just dropped off the face of the earth and couldnt get it back. This graph provides the three most important metrics graphed simultaneously: Jitter, Packet Loss, and Latency.This Cisco connects to another by VPN and both are 871 Models. To provide the most complete information, we recommend running the test for a minimum of 2 hours or for at least the duration of your business hours, if not 24 hours. From this, the 8x8 Network Engineering team can provide recommendations to resolve the issue.Ī complete graph is created showing the results over the duration of the test. This information is read by 8x8’s Network Engineering team (or your IT Staff) to identify where packet loss or latency is being introduced into the call. Over time a graph is created to the right of the application providing statistics of packet loss and latency for each individual hop between your PC and the data center. The testing for Google will be used for a baseline. Right-click on Min and add the Maximum Latency field.In the target field type in, or the closest top-level domain for the region.Click the + at the top left of the program to create a new trace.Also ensure Focus is set to '' All'' and Interval is set to '' 2.5 seconds''.Right-click on the top bar, over Avg, Min, Cur, and check Maximum Latency.In the Target Name or IP field, enter the IP address of the recommended data center.After PingPlotter is installed and running:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |